POWXG30033 EN
Copyright © 2021 VARO P a g e | 7 www.varo.com
10 INTELLIGENT LINE FEED
When initially switching on the trimmer, a small length of line is fed out.
A ‘clattering’ noise will be heard when the lines hit the line cutter. DO NOT BE ALARMED this
is quite normal. After about 5 seconds the line will be cut to the correct length and the noise
will reduce as the motor receives full speed.
If the noise of the line being cut can’t be heard, more line will be fed out.
This trimmer has an intelligent line feed, so the spool will automatically feed more line when
needed, and when the line is subjected to some resistance.
No need to stop machine, as this system will act itself.
Make sure that line is fed out before operation. Make sure motor is up to full speed before
trimming.
Use only 1.60mm diameter cutting line. Other sizes of line will not feed properly and will result
in improper cutting head function or can cause serious injury. Do not use other material such
as wire, string, rope, etc. Wire can break off during cutting and become a dangerous missile
that can cause serious injury.
11 TROUBLE SHOOTING
▪ Line is welded to itself
▪ Not enough line on the spool
▪ Line has worn too short
▪ Line is tangled on the spool
▪ Lubricate with a silicone
spray
▪ Replace the spool
▪ Remove the spool and feed
line out
▪ Remove line from spool and
rewind
To Next Page
Loading...