SIDE DISCHARGE CHUTE
1. Lift the spring-loaded discharge cover located on the side of the
mower.
2. Slide two hooks of the side discharge chute under the hinge pin
and lower the spring on the side discharge cover.
Caution: Do not attempt to remove the permanently mounted spring
loaded side discharge cover at any time.
ADJUSTING THE CUTTING HEIGHT
Warning! Cutting height adjustments should only be performed after the engine and blades
have come to a complete stop!
It is always best to begin cutting your lawn with a higher deck height to prevent scalping your lawn.
The cutting height is adjusted with a single lever.
Actuate the adjustment lever and pull it to the required position. Please make sure that the lever locks into
position.
Cutting height adjustment lever
To Next Page
Loading...
