KNOW YOUR SNOW THROWER
10
2. Engine RUN/STOP Rocker Switch
The Engine Rocker Switch enables and disables the ignition system. Turn the engine switch to the
RUN position to start the engine. Turn the Engine Rocker Switch to the STOP position to stop the
engine.
3. Fuel Control Knob
The Fuel Control Knob opens and closes the passage between the fuel tank and carburetor. The Fuel
Control Knob must be in the “ON” position for the engine to run. When the engine is not in use, be
sure to turn the Fuel Control Knob to the “OFF” position.
4. Safety Key Switch
The Safety Key Switch enables the engine electrical system and must be installed to start the engine.
5. Primer Bulb
The Primer Bulb system is designed to enrichen the fuel mixture for starting a cold engine. DO NOT
over prime the fuel system. To properly use the Primer Bulb system, depress Primer Bulb 3 times
maximum when starting a cold engine. Do not use Primer Bulb system when attempting to start a
warm engine.
6. Oversized Recoil Handle
The engine is started by pulling the Recoil Handle. Always grip firmly and have your body positioned
properly when pulling. When starting the engine:
· Slowly pull Recoil Handle until resistance is felt.
· Then pull firmly the full length of the rope to start engine.
· Never wrap thumb around Recoil Handle in the event of engine kick-back.
7. Oversized Gas Cap
Allows for easy opening and closing for more efficient refueling.
8. Electric Start (If Equipped)
Used to start the engine with 120VAC extension cord. Always use correct size extension cord to
prevent electric starter damage.
To Next Page
Loading...
