SPECIFIC SAFETY WARNINGS
• Before using the Pocket Hole Jig, be sure everyone using the
product reads and understands all safety instructions and other
information contained in the drill manufacturer's manual.
• The drill bit is sharp. Handle with care.
• Avoid awkward hand positions where a sudden slip could
cause contact with the rotating bit.
• Properly secure your workpiece before drilling. Do not attempt
to hold the Pocket Hole Jig in place with your hand while
drilling. Secure it to the workpiece with a clamp.
• Do not allow familiarity gained from frequent use of tools
replace safe work practices. A moment of carelessness is
sufcient to cause severe injury.
UNPACKING Refer to Figure 1
Check for shipping damage. Check immediately whether all
parts and accessories are included.
ITEM DESCRIPTION QTY
A
Pocket Hole Jig 1
B
Dust Collector Adapter 1
C
3/8" Drill Bit 1
D
R2 Driver Bit 1
E
Hex Key 1
F
3/8" Stop Collar 1
G
Carry Case 1
H
#7-1" L Coarse Square Drive Pan-Head Screws 10
I
#8-1-1/4"L Coarse Square Drive Washer-Head Screws 10
J
#8-1-1/2" L Coarse Square Drive Washer-Head Screws 10
K
#8-2"L Coarse Square Drive Washer-Head Screws 10
L
#8-2-1/2"L Coarse Square Drive Washer-Head Screws 10
WARNING
The Pocket Hole Jig arrives completely assembled. Before
using, make sure to read and understand this entire operating
manual and the operating manual of the drill being used.
Figure 1
DUST COLLECTOR ADAPTER
See Figure 2. The Pocket Hole Jig is equipped with a dust
collector adapter, it can be used with or without the adapter.
1. Snap the dust collector adapter onto the top of
the Pocket Hole Jig.
2. Connect it to a dust extractor or dust collector.
3. Adjust the dust collector adapter to the needed position, it
can be rotated over 180°.
Figure 2
SET UP - TO DRILL POCKET HOLES
1. Measure the material thickness.
2. See Figure 3. On the side of the Pocket Hole Jig is a material
thickness alignment mark and measurements.
3. Slide the body of the Pocket Hole Jig in or out to align
the alignment mark with the measurement of the material
thickness.
4. Example shows mark is aligned to 3/4" material thickness.
Figure 3
To Next Page
Loading...
