Need help?Do you have a question about the PowerTech PC170 and is the answer not in the manual?
General| Brand | PowerTech |
|---|---|
| Model | PC170 |
| Category | Control Panel |
| Language | English |
Details the steps for installing the control box, including mounting and wiring connections for accessories and motors.
Configures SW3 settings for photocell connections, detailing options for one or two sets and no photocells.
Configures gate motor behavior like slowdown, over-current, and auto-close using SW1 DIP switches.
Adjusts safety features and gate operation modes using SW2 DIP switches.
Configures automatic gate closing delay times based on SW1 DIP switch combinations.
Configures pedestrian mode and flashing light behavior using SW1 DIP switches.
Configures photocell behavior for gate safety and operation based on SW2 DIP settings.
Explains how gates respond to transmitter, push button, or key selector commands and safety features.
Details advanced transmitter functions and button assignments based on SW3 DIP settings.
Addresses issues like gates not moving, short transmitting distance, or slow motor operation.
Diagnoses problems with sudden stops, one-directional movement, or noisy motors and relays.
Provides technical details for the safety photocells, including detection method, range, and voltage.
Details the wiring connections for the photocell transmitter (TX) and receiver (RX) to the control board.
To Next Page