INSTRUCTIONS PL600H/PL1000H
17
2 channel transmitter
4 channel transmitter
(A)Button: “Open- Stop- Close- Stop”
(B)Button: Long Press for other device
turn-on, like garage door system
(A) Button: “Open- Stop- Close- Stop”
(B) Button: Long Press for other device
turn-on, like garage door system
(C) Button: “Pedestrian mode”
Or
(D) Button: “Pedestrian mode”
(A)Button: “Open- Stop- Close- Stop”
(B)Button: “Pedestrian mode”
(A) Button: “Open- Stop- Close- Stop”
(B) Button: “Pedestrian mode”
(C) Button: Long Press for other device turn-on,
like garage door system
Or
(D) Button: Long Press for other device turn-on,
like garage door system
Channel/Functions SW2 switch on SW2 switch off
1). The transmitter Reaction
LED1 Photocells
LED2 Photocells
LED3 RF Learning
LED1 will be on when the first pair of the photocells are activated.
LED2 will be on when the second pair of the photocells are activated.
LED3 will be on when RF-learn button is pressed.
LED Indication Descriptions
4.1.2 Recognition of LED
4.1.3 Checking the Gate Movements
1). Release the gearmotor with the release key and move the gate to the middle so that it is free to move in both
opening and closing directions; then lock the gearmotor.
2). Perform the gate opening and closing several times and make sure the gates reaches the limit switch at least 2~3
centimeters before the mechanical stop.
Important notice:
(1) Jumper 4: ② and ③ in place: remote control button (C) usable ;
Jumper 4: ① and ② in place: remote control button (D) usable.
(2) Pedestrian mode follows function “F6-0~F6-5” settings.
2). The transmitter Learning
Press “RF Learn” button for 2 seconds, and the LED3 is on; then press the transmitter (A) button; the LED3 will blink
twice and then be off. The system learning is complete.
3 2 1 3 2 1
Button (C) Usable Button (D) Usable
To Next Page
Loading...
Need help?
General
