PowerXL SplitBrew CM0122-1BPLA - Page 30

30 PowerXL
™
SplitBrew
™
Troubleshooting
PROBLEM POSSIBLE CAUSE SOLUTION
Thelterbasket
overows.
The carafe has been
removed for longer
than 30 seconds
whenusingthe
Sneak-A-Cup feature.
Excessiveamount
of coffee is used.
Brewingwithsoftened
water.
Make sure to replace
thecarafewithin
30 seconds during
thebrewingcycle.
Reduce the amount
of coffee used.
Alwaysbrewwithcold,
lteredwater.
Coffee sediment is be-
ing deposited into the
carafe.
Thelterand/orthe
brewbasketarenot
properly placed.
Coffee grounds are
small enough to pass
through the permanent
lter.
The coffee maker
needs cleaning.
Insertthelterand
basket properly.
While it is normal
to see some coffee
sedimentwhenusing
apermanentlter,
a coarser grind can
reduce the amount
of sediment.
The coffee maker
brewsslowly.
The coffee maker needs
cleaning.
Followtheinstructions
in the AUTO CLEAN™
SYSTEM section
More than one cleaning
cycle may be required
if the coffee maker is
heavilycalcied.
The coffee maker does
notbrewallwaterinthe
reservoir.
The coffee maker needs
cleaning.
Followtheinstructions
in the AUTO CLEAN™
SYSTEM section. More
than one cleaning cycle
is probably needed.
If additional assistance is needed, please contact our consumer service team at
1-800-577-1557.