11
Antenna Configuration 2
Adhesive Mounting
• Clean the entire surface on which you plan to
stick the antenna.
• Remove the nut and short spigot from the
antenna.
• Secure the magnetic base to the antenna with
flat head screws.
• Peel off the wax paper layer and stick the foam
seal to the magnetic base.
• Peel off the second wax paper layer and firmly
press the antenna down onto the surface.
• Route the cable as required.
Exploded View
Antenna Configuration 3
Magnetic Mounting
• Clean the entire surface on which you plan to
stick the antenna.
• Remove the nut and short spigot from the
antenna.
• Secure the magnetic base to the antenna with
flat head screws.
• Place the antenna onto the magnetic surface.
• Route the cable as required.
To Next Page
