8
Securing the antenna
• Remove the plastic nut from the antenna.
• Fasten the required spigot with the Flat head
screws.
• Clean the plastic surface of the antenna base
and threaded spigot.
• Insert the antenna cables inside the provided
Base Seal.
• Carefully slide the antenna cables through the
drilled hole.
• At the interior of the mounting surface, Insert
the antenna cables into the provided Spigot
Seal and push it up to the bottom of the
mounting surface through the spigot.
• Tighten the plastic nut onto the Spigot so that
it compresses the Base and Spigot Seal.
Note: Be careful not to overtighten the nut.
Important Information for Spigot Mount
Antenna Installation
To ensure optimal functionality and protect your
vehicle from potential water damage, please
follow these guidelines for spigot mount
installations of your POYNTING antenna:
To Next Page
Loading...
