PPA Agility Hibrida - EU Declaration of Incorporation; Manufacturer and Product Compliance Details

46
EU DECLARATION OF INCORPORATION OF PARTLY COMPLETED MACHINERY
Identication Number: CE PPA 002 (Revision: 0)
Manufacturer:
CompanyName: MOTOPPARINDÚSTRIAECOMÉRCIODEAUTOMATIZADORESLTDA.
Address: AV. DR LABIENO DA COSTA MACHADO, 3526
GARÇA, SÃO PAULO, 17406-200 - BRASIL
Authorized Representative / Person authorized to compile the Technical File:
CompanyName: AUTOMATISMOSPPAEUROPAS.L
Address: CALLE JOAN FUSTER ORSTELLS, 13, LOC-3
SAINT FELIU DE LLOBREGAT, 08980, BARCELONA - ESPAÑA
This declaration of conformity is issued under the sole responsibility of the manufacturer, which
declares that:
The following partly completed machinery is the object of this declaration:
ProductType: Controlboardtooperatorsfordoors,gates,barriersandothers.
Models: TriexConnectBrushless24VCE,TriexConnectCE,TriexConnectFullRangeCE,
 TriexConnectDuplaCE,AgilityHibridaCE.
The object of the declaration described above is in conformity with all applicable requirements of
Directive 2006/42/EC on machinery.
The object of the declaration described above is in conformity with the relevant Community
harmonization legislation:
DIRECTIVE 2014/30/EU OF THE EUROPEAN PARLIAMENT AND OF THE COUNCIL
of26February2014ontheharmonisationofthelawsoftheMemberStatesrelatingtoelectromagnetic
compatibility
DIRECTIVE 2011/65/EU OF THE EUROPEAN PARLIAMENT AND OF THE COUNCIL
of8June2011onthererictionoftheuseofcertainhazardoussubancesinelectrical and electronic
equipment
The relevant harmonised 󰎣andards considered for compliance are:
Machinery Directive (2006/42/EC):
BS EN 60335-1:2012+AC:2014+A11:2014, BS EN 60335-2-103:2015
EMC Directive (2014/30/EU):
EN IEC 61000-6-2:2019, EN IEC 61000-6-3:2021
RoHS Directive (2011/65/EU).
The relevant technical documentation is compiled in accordance with Annex VII, part B of
Directive 2006/42/EC;
In response to a reasoned reque󰎣 by the national authorities, the relevant information will be
transmitted;
The partly completed machinery mu󰎣 not be put into service until the nal machinery into which
it is to be incorporated has been declared in conformity with the provisions of the Machinery
Directive (2006/42/EC)
GARÇA, BRASIL - 18/11/2022
Samuel Peres
CEO
MOTOPPAR INDÚSTRIA E COMÉRCIO DE AUTOMATIZADORES LTDA.