PR electronics 3000 - Applications; Technical Characteristics

10 3000V101-UK
TEMPERATURE CONVERTERS
• Converts process measurements from Pt100, TC J and K temperature
sensors to voltage or current outputs
• Multiple pre-calibrated temperature ranges are selectable via DIP-
switches
• High accuracy, better than 0.05% and excellent 50/60 Hz noise
suppression
• Fast signal response time < 30 ms
• 3113 and 3337 with HART® 7 protocol and fast signal response time
< 60 ms
• HART® 7 protocol enables extended device programming for 3113 and
3337
• Slimline 6 mm housing
Applications
• The temperature converters measure standard 2-, 3- or 4-wire Pt100 and/or
TC J & K temperature sensors, and provides an analog voltage or current output.
• High3portisolationprovidessurgesuppressionandprotectsthecontrolsystem
from transients and noise.
• The loop powered devices have high 2-port galvanic separation to eliminate
ground loops.
• ThedevicescanbemountedintheSafeareaorinZone2/Division2areas.
• Approvedformarineapplications.
Technical characteristics
• Highconversionaccuracy,betterthan0.05%ofspan.
• AvisiblegreenLEDindicatesoperationalstatusandstatusoftheinputsensor.
• Allterminalsareprotectedagainstovervoltageandpolarityerror.
• MeetingtheNAMURNE21recommendations,thesystem3000devicesensure
top measurement performance in harsh EMC environments.
• ThedevicesmeettheNAMURNE43standarddefiningoutofrangeandsensor
error output values.
• Highgalvanicisolationof2.5kVAC.
• Excellentsignal/noiseratioof>60dB.