To Next PageTo Next Page
Need help?Do you have a question about the PR electronics 5202B and is the answer not in the manual?
General| Supply Voltage, Nom. | 24 VDC |
|---|---|
| Input | RTD, TC, Ohm, mV |
| Vibration | IEC 60068-2-6 |
| Mounting | DIN rail |
| Protection Class | IP20 |
| Communication | HART |
| Loop Current | 4-20 mA |
| Input Range | Dependent on sensor type |
| Output | 4-20 mA |
| Output Range | 4-20 mA |
General safety instructions and potential hazards for module operation.
Warning regarding connection to hazardous voltages and ESD-safe conditions.
Safety precautions for keeping safe distances during installation.
Defines hazardous voltages and qualified personnel for module operation.
Guidelines for unpacking the module and checking its type.
Precautions regarding environmental conditions for module operation.
Requirements for qualified personnel and contact information for assistance.
Compliance with national legislation for electrical mounting and power switch requirements.
Procedures and safety for calibration and adjustment.
Guidelines for safe operation by authorized personnel.
Method for cleaning the module.
Disclaimer regarding liability if instructions are not followed.
Lists key features like channels, isolation, and error detection.
Describes applications such as NAMUR sensors and mechanical contacts.
Details relay types, galvanic separation, and SIL 2 suitability.
Information on mounting vertically/horizontally on a DIN rail.
Specifies the product order code and available output types.
Details the operating temperature range and common electrical parameters.
Specifies input types, frequency range, pulse length, and resistance.
Details maximum frequency, voltage, current for outputs.
Lists ATEX certifications and applicable zones.
Provides specific data for Ex/I.S. applications like voltage and inductance.
References the UL control drawing number.
Configuration of signal transmission and cable error detection using jumpers.
Settings for transferring channel 1 signal to channel 2 and input 2 function.
Defines the Normal Open (N.O.) and Normal Close (N.C.) functions for 5202B4 relays.
Illustrates connection examples for NAMUR sensors and mechanical contacts.
Schematic diagram showing internal connections for 5202B1 and 5202B2 models.
Schematic diagram showing internal connections for the 5202B4 model.
Shows terminal connections for the power supply.
Details input connections for NAMUR sensors and contacts.
Illustrates output connections for relay and open collector outputs.
