6/18
SETUP OPTIONS-PROJECTOR CONFIGURATION
Projector configuration can be set conveniently via push-button switch and LED display.
Launch the projector and press button ENTER for more than 5 seconds to unlock the panel, the LCD will show the
function menu of the projector, each main menu has its submenus and each submenu has a specific function. For
details, please see the “OPERATION MENU” section.
Press button UP or DOWN if you want to browse through the various Setup Options. Press button ENTER to save your
settings or enter the next menu. Press button UP or DOWN to shift.
Press button FUNC, it will return to the upper menu one by one or browse through the main menu.
TO SET THE DMX START ADDRESS
Each unit must be given a DMX start address so that the correct projector responds to the correct control signals. This
DMX start address is the channel number from which the projector starts to “listen” to the digital control information being
sent out from the controller. The PR-8800 have 3 DMX modes, which are standard mode, extended mode and short
mode. For example, the standard mode has 11 channels, so set the No. 1 projector’s address 001, No. 2 projector’s
address 012, No. 3 projector’s address 023, No. 4 projector’s address 034, and so on.
Launch the projector. Press button ENTER for more than 5 seconds to unlock the panel.
Press button FUNC, UP or DOWN to find “AddR” menu.
Then press ENTER to show DMX address and press UP or DOWN to set DMX address.
At this time, the address will flash continuously. Press button ENTER to confirm and it means the setting has been
enabled.
Press button FUNC, it will return to the upper menu one by one.
To Next Page
Loading...
