PR Lighting XPar 348 - Operation Menu

7/18
OPERATION MENU
1st LEVEL 2nd LEVEL 3rd LEVEL 4th LEVEL
AddR
(DMX address)
XXX
（XXX:1~512）
CNFG
(Config settings)
dmX
(DMX mode)
STd
(Standard mode)
EXT
(Extended mode)
SHRT
(Short mode)
dISP
(Display settings)
ON
OFF
(Shut off digital CRT without
pressing buttons in 5 minutes)
mORS
(Master /Slave Settings)
SLAV
(Slave)
mAST
(Master)
FACT
(Reset factory setup)
yES
TRmd
(Transmit
parameters)
yES
INFO
(Information)
TImE
(Power on hours)
XXXX
TEm
P
(LED board temperature)
XX
VER
(Version)
X.X.X
TEST
(Test mode)
R
(red)
G
(green)
B
(blue)
W
(white)
RG
b
(Red/green/blue)
Rw
b
(Red/white/blue)
RGb
w
(Red/green/blue/white)
mENU
(Operation mode)
dmx
(DMX mode)
PR X
X
(Preset memory, PR01~PR16）
ET XX
(User memory,ET01~ET16）
COL1
(Colour 1)
X
X
(Number: 0~14)
COL
2
(Colour 2)
X
X
(Number: 0~14)
COL
3
(Colour 3)
X
X
(Number: 0~14)
COL
4
(Colour 4)
X
X
(Number: 0~14)
Note:
1. When multiple projectors’ work together in
synchronous control state, Parameters can be transmitted from the
master projector to the slave projectors in the following conditions, such as DMX channel mode, Display setting
status and operation mode (User memory data is included).
2. Projectors which receive Parameters transmitted shall be set slave automatically.
3. What “Number” in “ET XX” submenu represents refer to the following blank.