10
SEQUENTIAL CHARGING
Note: The time-delayed allocation of the charging current is not supported by all electric vehicles.
A charging current of at least 6A is required for each vehicle to be charged.
If the wallbox has been configured for a low charging current, this may mean that not both vehicles can be charged at the same
time. In this case, the two connected vehicles are charged one after the other (sequentially).
If the charging process of the second vehicle does not start automatically, it may be necessary to disconnect the vehicle from the
system for a short time first. After reconnection, the charging process starts.
As a precaution, observe the connection sequence to the box. First connect the vehicle that does not support sequential charging.
Only then connect the second vehicle (sequential charging is supported by this one).
RESTARTING THE BOX
To restart the box, first disconnect all vehicles from the system.
Switch off the wallbox's internal RCD for 5 seconds.
After switching on the voltage, the microcontroller of the box restarts automatically.
Within 2 seconds, the box signals the preselected setting by white flashing of the LEDs, e.g. 10 flashes signal a presetting of 10
amps.
MAINTENANCE AND CLEANING
In the event of a defect, please contact the manufacturer directly.
For safety reasons, the wallbox must be disconnected from the mains before cleaning.
Dirt can be removed with a damp cloth.
The use of harsh cleaning agents is not permitted.
The wallbox must not be cleaned with a water jet or high-pressure cleaner.
ENVIRONMENT
Dispose of the packaging material via the collection containers for paper and plastics provided for your region.
The disposal of old appliances and their accessories is carried out in accordance with the national and regional regulations for the
disposal of electrical and electronic appliances. Accordingly, these must not be disposed of with household or bulky waste.
To Next Page
Loading...