PRASTEL UNIK2E-V2 - Table of Contents

UNIK2E V2
ENGLISH
ISUNIK2Ev2_GB_02_09.doc
2
1. INTRODUCTION ...........................................................................................3
2. MAIN FEATURES .........................................................................................3
3. TECHNICAL SPECIFICATIONS...................................................................3
4. CONNECTION AND SET UP OF THE CONTROL UNIT..............................4
4.1 GENERAL DIAGRAM OF SETTINGS AND CONNECTIONS..................................5
4.2 SIMPLIFIED LEARNING PROCEDURE (also see pages 8-10)..............................6
4.3 PROFESSIONAL LEARNING PROCEDURE (see also pages 8-10)......................7
5. CONTROL UNIT OPERATING LOGIC (ANALYTIC EXAM) ........................ 8
5.1 PROGRAMMING AND CANCELLATION OF THE REMOTE CONTROLS.............8
5.2 OPERATION OF THE SAFETY DEVICES ...............................................................8
5.3 MOTOR SPEED - TRIMMER “FOR”.......................................................................9
5.4 DELAY BETWEEN MOTORS - TRIMMER “DEL” ..................................................9
5.5 “OPENING AND CLOSING” OPERATING MODE ..................................................9
5.6 “PEDESTRIAN OPENING” FUNCTION.................................................................11
5.7 “OBSTACLE SENSITIVITY” DETECTION - TRIMMER “OBS”.............................11
5.8 FLASHING LIGHT ..................................................................................................11
5.9 GATE OPEN WARNING LIGHT .............................................................................11
5.10 SLOW-DOWN .........................................................................................................11
5.11 ELECTRIC LOCK ...................................................................................................11
5.12 COURTESY LIGHT.................................................................................................12
5.13 BUFFER BATTERY – SOLAR PANEL MANAGEMENT .......................................12
5.14 LOGICAL STOP (STP INPUT)................................................................................12
5.15 CONTROL UNIT MEMORY FAULT........................................................................12
6. SIGNALLING LED....................................................................................... 12
7. PROGRAMMING THROUGH GTSYSTEM................................................. 13
8. ACCESSORIES ABSORPTION CHECK INFORMATION..........................13
9. TROUBLESHOOTING ................................................................................14
SAFETY WARNINGS FOR INSTALLATION AND USE ...................................................15
Intelligent Security & Fire Ltd.