Step 7: Cleaning the Oven Cavity
• Apply oven cleaner to a dry cloth or scrub pad and wipe down the sides
of the cavity.
• If large buildup occurs, you may spray the cleaner directly in the
affected area and allow to sit for a small period of time to allow cleaner
to break u buildup.
• Do not spray IR element directly.
• Do not use a wire brush or steel wool to clean cavity as it can cause
damage to interior walls.
WARNING: Do not use water hose or jet to clean cavity.
Step 8: Wiping Down Oven Cavity
• Wipe down the oven cavity with a damp cloth or towel.
• Do a final pass with a dry cloth or towel to remove as much left over
cleaner and debris as possible.
Step 9: Cleaning the Oven Door
• Spray the cleaner on a nylon scrub pad or cloth to clean oven door.
• If buildup occurs, you may spray the cleaner directly on the affected
area.
• Dry down using a dry cloth or towel.
Step 10: Apply Oven Guard
• Apply the oven guard to a dry cloth or towel.
• Wipe all surfaces of the cavity avoiding the IR element.
• The guard will aid in preventing large buildup from occurring.
Step 11: Reinstalling Components
• Reinstall the catalyst inside the holding brackets. Make sure to push it
all the way down to prevent the bottom jetplate from pushing against
it.
• Reinstall bottom jetplate and rack assembly.
• Close the door and insert filter back into position and close the filter
tray
• Reinstall bottom panel under door.
To Next Page
Loading...
