Model No. TT-3500
Page7of7
Feb 2010
TROUBLE SHOOTING
If your induction unit appears not to be working properly, it doesn't necessarily mean it's faulty. In all
cases, check the following points.
Malfunction Check…..
No indication light when power "on" Cable/terminal block is loose
Broken circuit of fuse; or automatic switch in the
power supply
No Power supply
Heating indicator does not light, or is
flashing,
Unsuitable cooking utensil
Appliance fails to heat up No pan on the ceramic top
Utensil is not located at the centre of the ceramic
plate
Utensil is smaller than 5cm
Appliance suddenly stops heating
during operation
Over-heating protection activated
Air entrance or outlet is blocked.
Air filter is dirty.
High ambient temperature
Error Code,
It may be ……. Error Code by Beeper Error Code by Display
over-heat protection (top-plate) 1long 2 short E3
over-heat protection (heating empty pot/pan) 1long 19short E4
over-voltage protection (too high or too low) 1long 4short E6
over-current protection 1long 11short E9
If you fail to identify the problem contact the after-sales service without delay.
To Previous Page
Loading...