?
NOTE
Display Parameter
Setting Range
Unit Default Remark
IN.SL
IN.FL
BSL
RSL
BSP1
BSP2
BSP3
BS0
BS1
BS2
BS3
BS4
Min Input
Value Scale
0.0 mV, V
PV Filter
OFF, 1 to 120
sec OFF
Open Sensor
Behavior
OFF, UP, DOWN
ABS UP
Not Used for
VDC input
RJC Operation
ON, OFF
ABS ON
Only Used for
TC Input
Reference Bias
Point 1
AEU (0.0 to 100.0%),
RL≤BSP1≤BSP2≤BSP3≤RH
AEU
AEU
(100.0%)
Reference Bias
Point 2
AEU (0.0 to 100.0%),
RL≤BSP1≤BSP2≤BSP3≤RH
AEU
AEU
(100.0%)
Reference Bias
Point 3
AEU (0.0 to 100.0%),
RL≤BSP1≤BSP2≤BSP3≤RH
AEU
AEU
(100.0%)
Bias Value for RL
Point
GEU (-100.0 to 100.0%)
GEU 0
Bias Value at
BSP1
GEU (-100.0 to 100.0%)
GEU 0
Bias Value at
BSP2
GEU (-100.0 to 100.0%)
GEU 0
Bias Value at
BSP3
GEU (-100.0 to 100.0%)
GEU 0
Bias Value
at RH
GEU (-100.0 to 100.0%)
GEU 0
IN-T
IN-U
IN.RH
IN.RL
IN.DP
IN.SH
Input Type
Refer to Table 1: Universal Input Selection
ABS TC.K1
Display Unit
ºC / ºF
ABS
ºC
T/C, RTD
Max PV
Display Range
Within sensor input range
Refer to Table 1
INRH > INRL
AEU 1370
Min PV
Display Range
AEU -200
Decimal Point
Position
0, 1, 2, or 3
ABS 1 mV, V
Max Input
Value Scale
-1999 to 9999
INSH > INSL
Decimal position determined by IN.DP
ABS
100.0 mV, V
There are two types of engineering units values used in the setting of parameters, absolute
engineering units (AEU) and general engineering units (GEU). An AEU parameter is set using an
absolute value engineering unit that represents a specific point, such as a specific temperature or
voltage level. An GEU parameter is set using engineering units, however it is a general value, and not
tied to any input or output level.
For example: When establishing input bias, parameter BSP1 sets the specific PV value where bias
point one will occur. This parameter has a unit designation of AEU. BS1, the amount of offset at BSP1
is set in engineering units, however this parameter occurs at whatever BSP1 is set to, and therefore
does not have an absolute setting related to any input or output, it is just the amount of offset at where
BSP1 occurs. While one is related to an absolute input value, and the other stand alone value, both are
set as engineering units, such as BSP1 set as 100ºC and BS1 set as 3ºC.
Input Group Parameter Summary
PD570 Series Nova Process and Temperature Limit Controller Instruction Manual
17
To Next Page
Loading...
Need help?
General