7.2 Panel Mounting
PD570
PD578
Installation Steps
1. Cut the mounting panel. (Refer to 7.1 Dimensions and Panel Cutouts)
2. Insert the controller through the front of the panel rear terminals first.
3. On applicable models, attach the right and left mounting bracket and secure it to the panel.
4. On 1/16 DIN controller models, slide the mounting bracket onto the back of the controller as shown, and slide it
forward on the controller until the bracket locks in place, and the controller is secure.
Do not excessively tighten the mounting bracket screws. Excessive tightening may lead to
controller or panel damage.
!
CAUTION
Panel
Mounting Bracket
Panel
Mounting Bracket
PD570 Series Nova Process and Temperature Limit Controller Instruction Manual
32
To Next Page
Loading...
Need help?
General