Precision matthews PM-1022V

1
PM-1030V v5 2020-10 Copyright © 2020 Quality Machine Tools, LLC
Models PM-1022V & 1030V
110 Vac 1 HP fully equipped machine
Variable speed DC motor
Spindle speeds from 50 to 1000 & 100 to 2000 rpm
* 30 in. (22) between centers, 10 in. swing over bed
Spindle bore: 1 in. clearance
3-jaw and 4-jaw chucks
Faceplate, steady & follower rests
Quick change tool post & tool holders
Gearbox and change gears for full-range screw cutting, U.S. (TPI) & Metric
Bi-directional power feed for saddle & cross-slide
Weight, excluding stand approx. 395 (360) lb
* Models PM-1022V & PM-1030V
This manual was written for the Model PM-1030V. The PM-1022V is
identical in all respects other than overall weight and bed dimensions.
Items specic to the PM-1022V are noted in this color, italic.

Precision matthews PM-1022V Specifications

General

Swing Over Bed	10"
Distance Between Centers	22"
Tailstock Taper	MT3
Motor Power	1 HP
Voltage	110V

Summary

Models PM-1022 V & 1030 V Introduction

Key Machine Features

Overview of the lathe's primary capabilities and specifications.

PM-1030 V FAQ

Troubleshooting Motor Start Issues

Common questions and answers regarding the motor not running.

Section 1 INSTALLATION

Installation Preparation and Setup

Essential points, warnings, lifting, and initial checks.

Lathe Leveling and Alignment

Procedures for ensuring the machine is level and centers are aligned.

Optional Test Run Procedure

Steps for an initial operational check.

Section 2 FEATURES & SPECIFICATIONS

General Lathe Information

Overview of the lathe's design and capabilities.

Detailed Technical Specifications

Comprehensive list of dimensions, capacities, and performance data.

Everyday Precautions

Safe Operating Practices

Essential safety guidelines for daily use.

Section 3 USING THE LATHE

Drive System, Motor Control, and Speed

Operating the motor, speed control, and drive system.

Chuck and Faceplate Handling

Procedures for removal and installation of chucks.

Power Feed System Operation

Using saddle and cross-slide power feeds and their rate settings.

Saddle, Cross-Slide, and Compound Operation

Manual and powered movement of these components.

Tooling and Tailstock Usage

Using the QCTP and basic tailstock functions.

Thread Cutting Guide

Setups, procedures, and dial rules for cutting US and metric threads.

Steady and Follower Rests

Using support rests for workpiece stability.

Section 4 SERVICING THE LATHE

General Maintenance and Lubrication

Importance of care, lubrication points.

Gearbox and Apron Lubrication

Procedures for draining and refilling oil.

Lathe Adjustments and Alignment

Gibs, backlash, spindle bearings, and overall alignment.

Section 5 PARTS DIAGRAMS

Major Component Assemblies

Diagrams for Headstock, Gearbox, Apron, etc.

Electrical System Diagrams

Schematic, wiring, and motor control details.