3
PM-1030V v5 2020-10 Copyright © 2020 Quality Machine Tools, LLC
Feed direction Feed rate
Emergency
STOP
switch
Motor
ON/OFF
Forward/
Reverse
Safety switch
(disconnects
power when cover
is removed)
Two-step
Vee-belt
drive
External
change gear
train
Section 1 INSTALLATION
THESE ARE THE MAIN POINTS TO WATCH OUT FOR!
But read the following pages for more information
• Handling the lathe is at least a two-man job.
• Lifting gear – sling, hoist or forklift – must be rated for at least 1/2 ton.
• Care must taken when lifting to avoid exing or other damage to any component of the
lathe, especially the leadscrew and hex-section feed shaft.
• Working location of the lathe must allow space for opening drive system cover at left;
also, access to the electrical box at the back of the headstock.
• Power requirement is 110V, 60Hz, single phase.
• Extension cord not recommended; if no alternative, use 12 AWG not longer than 20 ft.
• Before connecting power be sure that:
1. The machine is on a rm footing.
2. Chuck attachment bolts are tight, no wrench left in chuck.
3. Saddle and cross-slide approx. mid-travel, power feed disengaged (Figure 1-2).
4. The speed control knob is set for a low or zero spindle speed, fully counter clockwise.
Check oil level in the gearbox and apron before use
Traveling
steady
Steady
rest
Headstock
Feed
speeds
& screw
threads
Spindle
speed
(tachometer)
Speed
control
3-jaw
self-center-
ing chuck
Chuck
guard
Quick change toolpost
(QCTP) AXA 100 Series
Compound
Cross-
slide
Tailstock
quill
Tailstock
Leadscrew
Lathe
bed
Saddle
hand-
wheel
Power
feed
lever
Half-nut
lever
Gearbox
Threading
dial
MAIN COMPONENTS
To Next Page
Loading...
Need help?
General
