2
PM 25MV v9 2021-12 Copyright © 2021 Quality Machine Tools, LLC
PM-25MV
FAQ
120 Vac power connected?
E-Stop button out? (pop it out
by twisting rmly to the right.)
Fuse good?
The CHIP GUARD switch may
be open. Close the guard.
The table won’t go
back to the column
The X-axis (table) lock handles
could be the problem. Swing
them up to clear.
R8 collets won’t go
into the spindle
The collet locating screw
could be in too far. Back it
out a little.
My mill doesn’t run
This manual contains essential safety advice on the proper setup, operation, maintenance, and ser-
vice of the PM-25MV milling machine. Failure to read, understand and follow the manual may result
in property damage or serious personal injury.
There are many alternative ways to install and use a mill. As the owner of the mill you are solely
responsible for its proper installation and safe use. Consider the material contained in this manual
to be advisory only. Quality Machine Tools, LLC cannot be held liable for injury or property damage
during installation or use, or from negligence, improper training, machine modications or misuse.
This manual describes PM-25MV machines as shipped from February 2016. There may
be detail dierences between your specic machine and the information given here (with
little or no impact on functionality). Please email us if you have questions about any aspect
of the manual or your machine (see our website www.precisionmatthews.com for support
addresses). Your feedback is welcomed!
Copyright © 2021 Quality Machine Tools, LLC
This material was originated by Precision Matthews. No portion of the manual may be repro-
duced or distributed in any form without the written approval of Quality Machine Tools, LLC.
The drawbar doesn’t
seem to be long enough
Install the drawbar UNDER the
drawbar cap, as in the photo
(unscrew cap, insert drawbar
into spindle, replace cap)
Drawbar
Cap
To Next Page
Loading...
Need help?
General
