C954i/C956i/C966i Treadmill Assembly Guide Addendum 2
Replace step 7 of the Assembly Guide with the following:
Lower the display console, align, and secure it to the upright
supports using six buttonhead screws (C), six split washers (H),
and six washers (D). Finger tighten.
Note: Sandwich each split washer between the head of the screw
and the flat washer. Refer to the illustration for proper placement.
Important: Do not wrench tighten the screws until the unit has
been fully assembled. Make sure the fasteners do not pinch the
cable. Cables damaged by improper installation will not be cov-
ered by the Precor Limited Warranty.
To Previous Page
Loading...
