page 27
COMMERCIAL PRODUCTS DIVISION
USING CSAFE STANDARD EQUIPMENT
The C936i is fully compatible with CSAFE protocols. If the unit is connected to a
CSAFE master device, the user will be prompted to enter a user ID. Five zeros
appear on the display. The left zero blinks to indicate that it is awaiting input. The
following table provides information about the keypad functions:
User ID Entry: Program Keys
INCLINE ▼ or ▲ moves the blinking LED from field to field.
SPEED ▲ or ▼ changes the number value in the selected field.
ENTER submits the displayed user ID. Note that if the 5 zeros are
being displayed when the user presses ENTER, user ID.
entry is bypassed and the program prompt appears.
RESET resets the display to the Precor banner.
A message indicates when the user ID is accepted by the CSAFE master
device. Then, the program prompt is displayed. See
Quick Steps to Working Out
on page 37.
To review information about CSAFE specifications, visit the web site at:
www.fitlinxx.com/csafe
Additional CSAFE commands supported by the C936i software include:
SetProgram, SerUserInformation, GetUserInformation, GetOdometer, and
GetErrorCode
To Next Page
Loading...
Need help?
Power and Motor
Weight and Dimensions
