page 46
COMMERCIAL PRODUCTS DIVISION
The C936i is built to withstand the rigors of the health club environment. However, as
club manager or owner, you are responsible for cleaning and maintaining the unit’s
integrity. If you fail to maintain the treadmill as described below, it could affect or void
the Precor Limited Warranty.
DANGER
— To reduce the risk of electrical shock, always unplug the unit
from its power source before cleaning it or performing any maintenance tasks.
INSPECTION
Perform a daily inspection of the treadmill.
1. Look and listen for slipping belts, loose fasteners, unusual noises, worn or
frayed power cords, and any other indications that the equipment may be in
need of service. Obtain service should you notice any of the above.
Important: If you determine that the treadmill is in need of service, move it away
from the main workout area and place an large “Out of Service” sign on it. While
it is awaiting service, remove the power cord so no one can use the treadmill.
2. Check for worn, frayed, or missing safety lanyards. Replace missing or worn
safety lanyards immediately. A safety lanyard with its security clip must be
fastened to the treadmill’s red STOP button. Do not allow users on a tread-
mill without it.
To order parts or to contact a Precor authorized service provider in your area,
refer to
Obtaining Service
on page 7.
CLEANING THE EQUIPMENT
Most of the working mechanisms are protected inside the treadmill’s hood and
solid base. However, for efficient operation, the treadmill relies on low friction. To
keep the friction low, the treadmill must be as clean as possible.
It is recommended that the running bed and belt be cleaned daily. Use a damp,
soft cloth to clean the staging platform, running bed and between the belt and
running bed surface as far as you can easily reach. This removes any dust or dirt
which might affect the smooth operation of the unit.
CAUTION: Never pour water or spray liquids on the display console, hand-
rails, or treadmill. Allow the treadmill to dry completely before using.
Periodically, clean the treadmill’s frame, display console, handrails and running
belt with a dampened (not dripping wet),
clean
cloth using a diluted solution
of mild soap and water. To clean the grooves on the belt, use a soft nylon
scrub brush. Vacuum the floor underneath the unit every week to prevent the
accumulation of dust and dirt.
The Precor Heart Rate equipment requires little maintenance beyond keeping it
dust free. Dampen a sponge or soft cloth in mild soap and water to wipe the chest
strap. Dry the surface thoroughly with a clean towel.
Maintenance
To Next Page
Loading...
Need help?
Power and Motor
Weight and Dimensions
