Precor EFX 883 - Installation Requirements and Hardware

Assembling the EFX 19
Installation Requirements
Prior to assembly, make sure you have the required tools and
hardware.
Hardware Kit (not to scale)
The hardware kit shipped with this equipment contains the
fasteners and other hardware components shown in the
following table. Before you begin assembly, make sure that
your hardware kit is complete. If not, please contact Precor
Customer Support.
Fasteners Quantity
Flat washers (⁵₁₆-inch) 14
Split washers (⁵₁₆-inch) 14
Flat head hex drive screws
(¹₄-inch x ⁵₈-inch)
4
Phillips-head machine screws
(#8 x ³₄-inch)
3
Buttonhead screws
(⁵₁₆–inch x 1–inch)
14
Sockethead cap screws
(#8 x 1¹₂-inch)
4
Self-tapping screws
(#8 x 1¹₂-inch)
4
Handlebar bolt wrench 1