32 Assembling and Maintaining Elliptical Fitness Crosstrainers: EFX 885 / 835 / 815
4. Fully tighten the fasteners using a ⁹₁₆-inch box-end
wrench.
Figure 17: Link arm attachment
5. Align the cut-out inside the link arm cap with the link arm
mounting hole. Apply pressure to the cap until it snaps
into place.
To attach the upright support covers and pivot arm caps:
1. Place one inner and one outer upright support cover
around one of the upright supports, aligning them so that
the arrows on their inside surfaces point toward the front
of the unit.
2. Line up the protrusions on the outer cover with the screw
holes on the inner cover.
3. Apply pressure to both covers so that the protrusions fit
firmly into the screw holes.
4. Secure the upright support covers using two self-tapping
screws.
Figure 18: Upright support cover attachment (right-hand
cover shown)
To Next Page
Loading...
