54 Assembling and Maintaining TRM 800-Series Treadmills
4. Line up the two small tabs at the bottom of the console’s
back cover with the slots at the bottom of the console
case. Insert the tabs into the slots.
5. Insert the two #8–32 × ¹₂-inch Phillips-head screws that
you removed earlier into the holes at the top edge of the
console’s back cover. Tighten the screws fully.
Important: If you are installing a console that is equipped
with a Personal Viewing System (PVS), use caution not to
pinch the cables between the back cover and PVS mounting
screw heads.
To Next Page
Loading...
Need help?
General
