To enter the Setup/Service mode:
1.
Begin pedaling. The Welcome screen appears.
Note You can only enter the Setup/Service mode from the Welcome screen.
2.
Press and HOLD down the
button while doing the following at the same time:
- Press and release the
button.
- Press and release the
button.
- Press and release the
button again.
- Press and release the
button.
3.
Release the
button.
Modifying the Club Parameters settings
Use Club Parameter settings to choose the type of information you want exercisers to see on the console while
working out.
Note Many of these settings can be defined on a formatted USB stick, which can then be used to set up multiple
consoles with identical settings. For more information, contact Precor Customer Support.
Description
Setting options (default in bold)
Speed and distance measurements
Three is the brightest setting
ASL SETUP
Active Status Light (ASL): Turns on and tests light so its color alerts
owner of bike maintenance issues
ON, OFF, YELLOW ON, BLUE ON
BT PAIRING
Turn ON so that exerciser’s can pair their phone to save their workout
information
SHORT, ON, OFF
MAJOR INSP
•
After routine inspection and maintenance, clear this setting to
reset the ASL to steady blue, clear the error log, and reset the
maintenance value back to the maintenance default.
•
The maintenance default is 1000 miles
•
Change this default using a Setup.ini file
KEEP
CLEAR
Select CLEAR to delete errors from the error log
DEVICE ID
The default number is based on the product lower serial number
Default ID # (Can be customized
using the blue button)
LANGUAGE
•
Service mode is English only
•
Select the language for all exercisers
ENGLISH, SPANISH, FRENCH,
GERMAN
For use with USB stick during setup
RESET
Returns all settings to factory defaults, except system information
(number of workouts, hours, and distance)
NO, YES
For use with USB stick during software upgrades