Precor Spinner Chrono Operator's Guide

Troubleshooting
Error
Information
Error
displays?
In error
log?
ASL
Change?
Possible Causes
Serious error
You cannot use
the console
Error
number
YES YES
• Connected to wrong lower
•
Communication error
Minor error
Console continues
to function
NO YES YES
RPM sensor stops working or strain gauge fails
causing WATTS inaccuracy, but a functioning
console.
Service
mode error
Only occurs during
USB access
Error
message
NO NO
• USB ACCESS – Unable to read USB stick
• USB FILE – File structure error on USB stick
• USB SETUP – Error in program.ini or setup.ini
STUCK KEY
error
Only detected
when the console
is powered up
STUCK
KEY
NO NO
Appears if you hold key down for at least three
seconds.
Console Care
Important DO NOT use any acidic cleaners to clean the console. Doing so will weaken paint, powder coatings, and other
surface finishes and will void the Precor Limited Warranty. Never pour water or spray liquids directly onto the screen.
Precor strongly recommends performing the following maintenance after each use:
o Spray a mild soap solution in a 30:1 water-to-cleaner ratio onto a soft cloth, and then wipe the console. Never
spray liquids directly onto the console or use abrasive cloths, oil, ammonia, or alcohol-based cleaners.
o Inspect each console for loose parts or bolts, and adjust and tighten loose hardware as needed. Remove any
consoles that are dam
aged, not properly mounted, or at risk of coming loose.
Spinner® Chrono™ Operator’s Guide | P/N 304657-101 rev A, ENU
©2017 Precor Incorporated | March 2017

Precor Spinner Chrono Specifications

General

Brand	Precor
Model	Spinner Chrono
Category	Fitness Electronics
Language	English