Page 11K&(%$*4.8"4,7%R'*#$"&8#J%/7*,#*%4,77%PSTTTSTQQSUVWV1ITEM 69727
F=K6EBF6E;XCX6I=E@C>D=@>E6>=><6
6. Allow the Engine to run for several seconds.
Then, if the Choke lever is in the START position,
move the Choke Lever very slowly to its RUN position.
>&$*- Moving the Choke Lever too
fast could stall the engine.
@DXCIE=>E- Allow the engine to run at no load for five minutes
after each start-up so that the engine can stabilize.
7. Adjust the Throttle as needed.
[(*,aS"8%X*("&9-
a. Breaking-in the engine will help to ensure proper equipment and engine operation.
b. The operational break-in period will last about 3 hours of use. During this period:
• Do not apply a heavy load to the equipment.
• Do not operate the engine at its maximum speed.
c. The maintenance break-in period will last about 20 hours of use.
• Change the engine oil after this period.
Under normal operating conditions subsequent maintenance follows
the schedule explained in the MAINTENANCE section.
F$&//"83%$.*%683"8*
1. To stop the engine in an emergency,
turn the Engine Switch off.
2. Under normal conditions, use the following procedure:
a. Slide the Throttle or Speed Control
Lever to SLOW (the “turtle”).
b. Turn the Engine Switch off.
c. Close the Fuel Valve.
NOTICE
See Long-Term Storage on page 15
for complete storage instructions.
FE=IE% I;>
6
C
@
CKK
To Next Page
Loading...
Need help?
General
