Predator 63086 - Page 20

Page 20 O&(%$*4.8"4,7%R'*#$"&8#N%/7*,#*%4,77%ST>>>T>;;TUVWV1 ITEM 63086
JAO6IF J6I?X GX6MAIDGB HADBI6BAB@6
X(&+7*5 X&##"+7*%@,'#*# X(&+,+7*%J&7'$"&8#
Engine misres 1. Spark plug cap loose.
2. Incorrect spark plug gap or
damaged spark plug.
3. Defective spark plug cap.
4. Old or low quality gasoline.
5. Incorrect compression.
1. Check wire connections.
2. Re-gap or replace spark plug.
3. Replace spark plug cap.
4. Use only fresh 87+ octane stabilizer treated
unleaded gasoline.%
P&%8&$%'#*%3,#&7"8*%)"$.%5&(*%$.,8%
S=l%*$.,8&7%]6SUN%6e=N%6>UN%*$41^1
5. Diagnose and repair compression.
(Use 683"8*%)"77%8&$%#$,($-%
@GHXM6JJDGB%M6EAI6P section.)
Engine stops
suddenly
1. Low oil shutdown.
2. Fuel tank empty or full of impure or low
quality gasoline.
3. Defective fuel tank cap creating
vacuum, preventing proper fuel ow.
4. Faulty magneto.
5. Disconnected or improperly
connected spark plug cap.
1. Fill engine oil to proper level. Check
engine oil before EVERY use.
2. Fill fuel tank with fresh 87+ octane stabilizer
treated unleaded gasoline.%
P&%8&$%'#*%3,#&7"8*%)"$.%5&(*%$.,8%
S=l%*$.,8&7%]6SUN%6e=N%6>UN%*$41^1
3. Test/replace fuel tank cap.
4. Have qualied technician service magneto.
5. Secure spark plug cap.
Engine knocks 1. Old or low quality gasoline.
2. Engine overloaded.
3. Incorrect spark timing, deposit buildup,
worn engine, or other mechanical problems.
1. Fill fuel tank with fresh 87+ octane stabilizer
treated unleaded gasoline. %%
P&%8&$%'#*%3,#&7"8*%)"$.%5&(*%$.,8%
S=l%*$.,8&7%]6SUN%6e=N%6>UN%*$41^1
2. Do not exceed equipment’s load rating.
3. Have qualied technician diagnose
and service engine.
Engine backres 1. Impure or low quality gasoline.
2. Engine too cold.
3. Intake valve stuck or overheated engine.
4. Incorrect timing.
1. Fill fuel tank with fresh 87+ octane stabilizer
treated unleaded gasoline. %%
P&%8&$%'#*%3,#&7"8*%)"$.%5&(*%$.,8%
S=l%*$.,8&7%]6SUN%6e=N%6>UN%*$41^1
2. Use cold weather fuel and oil
additives to prevent backring.
3. Have qualied technician diagnose
and service engine.
4. Check engine timing.
Product doesn’t
have power.
1. Product not plugged in properly.
2. Circuit Breaker tripped.
3. GFCI activated.
4. Product needs service.
1. Turn off and unplug the product, then
plug it back in again and turn on.
2. Turn off and unplug product. Reset Circuit
Breaker. Plug in product and turn on.
3. Turn off and unplug product. Test GFCI
receptacle. If functioning properly reset
GFCI, plug in product and turn on.
4. Have product repaired.
Product begins to
operate abnormally.
1. Problem with appliance.
2. Rated load capacity exceeded.
1. Immediately unplug appliance. Have
appliance repaired by a qualied
technician, or replace appliance.
2. Lower the number of items plugged into
the Generator to stay within the rated
capacity, or use a more powerful generator.
O&77&)%,77%#,2*$L%/(*4,'$"&8#%).*8*Q*(%9",38&#"83%&(%#*(Q"4"83%$.*%*R'"/5*8$%&(%*83"8*1
I(&'+7*#.&&$"83%]4&8$"8'*9^