Need help?Do you have a question about the Preen ADG-L Series and is the answer not in the manual?
Overview of ADG-L series features, models, and naming conventions.
Summary of the device's main capabilities, including configuration and I/O.
Detailed technical data and performance parameters for ADG-L series models.
Identification of front and rear panel components and their functions.
General setup requirements, environmental considerations, and installation notices.
Details on power input requirements, voltage, frequency, and wire selection.
Instructions for safely connecting the device to the power source.
Procedures for connecting the device's output terminals to a load.
How to use the remote sensing feature for accurate output voltage.
Setting up serial communication for remote control via RS-232/RS-485.
Step-by-step guide for safely powering on the device.
How to use the device's interface controls for local operation.
Display of output settings and measurement readings on the main screen.
Configuring the device for constant voltage output.
Configuring the device for constant current output.
Configuring the device for constant power output.
Accessing system, protection, and advanced settings.
Configuring overvoltage, overcurrent, and overpower protection limits.
Creating and running custom output sequences and test routines.
Operating multiple units in parallel or series for increased output.
Using the software for basic monitoring, control, and waveform display.
Using the software to create and run programmable output sequences.
Details on the Modbus RTU communication protocol, frames, and fields.
Breakdown of Modbus message components and their meanings.
Demonstrates Modbus communication commands and responses for various operations.
Table of Modbus registers for accessing device parameters.
Procedure to calibrate the accuracy of output voltage measurements.
Calibrating displayed and set voltage values for accuracy.
Procedure to calibrate the accuracy of output current measurements.
Calibrating displayed and set current values for accuracy.
Procedure to calibrate the accuracy of power measurements.
Essential guidelines and precautions for performing device maintenance.
General| Brand | Preen |
|---|---|
| Model | ADG-L Series |
| Category | Power Supply |
| Language | English |
To Next Page
