Premier RO-PURE Plus - System Startup and Flushing; Initial Startup Procedure; Tank Filling and Flushing

Page 12
Startup Instructions
If you have connected your RO system to a refrigerator / ice maker, make sure the ice maker is
RIIGRQRWDOORZZDWHUWRÀRZWRWKHLFHPDNHUXQWLOÀXVKLQJ6WHSLVFRPSOHWHDQGWKHWDQN
KDVEHHQDOORZHGWR¿OOFRPSOHWHO\&RQQHFWLRQIURPWKH52WRWKHLFHPDNHUV\VWHPVKRXOG
have an in-line valve installed before the ice maker so it can easily be closed to prevent water
ÀRZLQJWRWKHLFHPDNHUGXULQJVWDUWXSDQGSHULRGLFPDLQWHQDQFH<RXUVWRUDJHWDQNPXVWEH
DOORZHGWR¿OOXSIXOO\LQRUGHUIRUWKHLFHPDNHUV\VWHPWRZRUNSURSHUO\
$IWHUWKHVWRUDJHWDQNKDV¿OOHGRSHQWKH52)DXFHWWRÀXVKWKHWDQNFRPSOHWHO\<RXZLOO
NQRZWKDWWKHWDQNLVHPSW\ZKHQWKHÀRZUDWHIURPWKH52IDXFHWLVGRZQWRDWULFNOH5HSHDW
this step two more times. The fourth tank can be used for drinking.
Open the RO faucet and leave it open until water begins to trickle out (this may take a few
minutes and the water will come out slowly).
6WHS
Turn on the incoming cold water at the angle stop valve and the
$GDSWD9DOYH&KHFNWKHV\VWHPIRUOHDNVDQGWLJKWHQDQ\¿WWLQJV
DVQHFHVVDU\&KHFNIUHTXHQWO\RYHUWKHQH[WKRXUVWRHQVXUH
no leaks are present).
6WHS
6WHS
Note:
Step 1
&ORVHWKH52IDXFHWDOORZLQJWKHVWRUDJHWDQNWR¿OOZLWKZDWHU,WPD\WDNHWRKRXUVWR
¿OOWKHWDQNFRPSOHWHO\GHSHQGLQJRQWKHSURGXFWLRQFDSDELOLW\RIWKHPHPEUDQHORFDOZDWHU
temperature and water pressure.
Flushing of the tank 3 times is only necessary during the initial startup and after replacing the
membrane.
'XULQJWKH¿OOSHULRG\RXPD\KHDUZDWHUWULFNOLQJZKLFKLVDQRUPDORFFXUUHQFH
Note:
Note:
&RQJUDWXODWLRQV
You have completed the installation of your new Reverse Osmosis system.
Please Follow the Startup Instructions.
7KHÀXVKLQJSURFHVVVKRXOGWDNHDERXWDGD\WRFRPSOHWH
ON