What to do if incoming water pressure is too high for Premier RO-PURE?
If the incoming water pressure is above 100 psi for your Premier Water Filtration System, it is caused by excessive water pressure. To resolve this, install a water pressure regulator.
What to do if incoming water pressure is too low for Premier Water Filtration Systems?
If the incoming water pressure is under 40 psi for your Premier Water Filtration System, it is due to low water pressure. The suggested solution is to install a booster pump.
Why shouldn't I run reverse osmosis water through copper tube in Premier RO-PURE?
Running reverse osmosis water through a copper tube is not recommended for Premier Water Filtration Systems because the copper tube causes leaching of copper. Therefore, you should avoid running reverse osmosis water through copper tubing.
How to lengthen membrane life in Premier RO-PURE Water Filtration Systems?
If your Premier Water Filtration System operates with hardness over 10 grains, the membrane life may be shortened because of the high hardness level (over 10 grains per gallon). Consider adding a water softener to lengthen the membrane life.
Lists the necessary tools for setting up the RO system.
Details the system's components and how they connect via a diagram.
Instructions on how to create an opening for the RO faucet.
Guides through the process of installing the RO faucet, including tube connections.
Instructions for connecting the system to the water supply using the adapt-a-valve.
Details on how to install the drain saddle onto the sink's drain pipe.
Turn on water supply, check system for leaks, and tighten fittings as needed.
Open the RO faucet until water begins to trickle out slowly.
Close the RO faucet and allow the storage tank to fill completely over several hours.
Open the RO faucet to flush the tank, repeating this process multiple times.
Details the recommended replacement of sediment and carbon pre-filters every six months.
Addresses issues related to slow water output, covering low pressure and tubing kinks.
Details the specific parts and conditions covered by the Premier system's warranty.
Provides instructions on how to get warranty service, including return authorization.
Lists exclusions from warranty coverage, such as improper installation or misuse.
General| Daily Production Rate | 50 gallons per day |
|---|---|
| Tank Capacity | 3.2 gallons |
| Installation | Under Sink |
| Warranty | 1 year limited |
| Stages of Filtration | 5 |
| Filter Type | Sediment, Carbon, Reverse Osmosis, Post Carbon |
| Filter Life | 2-5 years for RO membrane |
To Next Page
