128-9345
Page 6 of 8
Page 6
NOTE: Always remember to exit Valet Mode to ensure that the vehicle
remains protected at all times.
ELIMINATING THE ARM / DISARM CHIRPS:
The normal arming and disarming conrmation "chirps" can easily be turned
on and off using the valet push button switch. To do this:
1. Turn the ignition key on, and then off.
2. Within 10 seconds of turning the ignition key off, press and release the
LED valet push button switch three times.
3a. If, before proceeding with step 2, the chirps were on, then you will hear
2 chirps to indicate that the chirps have been turned off.
3b. If, before proceeding with step 2, the chirps were off, then you will hear
1 chirp to indicate that the chirps have been turned on.
NOTE: Whenever the chirps are by-passed, the 3 chirp defect and 4 chirp
intrusion indicator will always operate. This feature will always
warn you if there is a defective sensor during the arming sequence
or if the vehicle had been tampered with in your absence, even if
the normal arming and disarming chirps have been turn off.
REMOTE PANIC OPERATION:
The Lock and Unlock buttons on your keychain transmitter also functions as
a "panic" switch for instant activation of the alarm in emergency situations.
To use the remote panic switch:
1. Press and hold the arming button on the keychain transmitter for 3 sec-
onds or more. The alarm will immediately sound.
2. To stop the alarm, press and release the Trunk/Key button on the key-
chain transmitter. If the button is not pressed, the alarm will automatically
stop after 30 seconds.
TRUNK RELEASE:
This security system has an additional feature that can be wired to a num-
ber of different optional accessories. Some of the more common uses for
this "channel" are:
Remote Trunk Release - available for any vehicle with factory installed
electronic push button trunk release.
To Next Page
Loading...
