128-9345
Page 7 of 8
Page 7
Remote Car Starter - available for most automatic transmission, fuel
injected vehicles.
Remote Window Roll Up - available for most vehicles equipped with
power windows.
TO ACTIVATE THIS OPTIONAL ACCESSORY
Press and hold the Trunk/Key button on the keychain transmitter for ap-
proximately 3 seconds. If the system has been programmed differently by
your installation center, this output may be accessed by pressing buttons
1 and 2 simultaneously for 3 seconds.
NOTE This feature will not operate when the vehicle's ignition key is
turned "ON".
Transmitter Model Name, 3BP Is Also Found On Back Of
Transmitter Case (Battery Use CR2032)
PROGRAMMING NEW OR REPLACEMENT TRANSMITTERS
(BANK 1)
1) Turn the ignition key to the ON position.
2) Press and release the valet/programming switch 3 times (Siren Chirps)
3) Press the Lock Button of each transmitter you want programmed until
you hear a chirp from the horn or siren.
4) Turn the ignition switch to the OFF position.
The above action programs the Lock, Unlock, and Start/Trunk, which are
typical for your systems.
To Next Page
Loading...
