Table 1. Go-Go Elite Traveller Plus Beep Codes
BEEP CODE FAULT IMPACT ON SCOOTER NOTES
BEEP CODE #3 Battery voltage is above 32VDC. Drive inhibited. Battery charge is too high. If the charger is plugged
(May Stop Slowly.) in, unplug it. Check battery charger output. Replace if it
exceeds 30VDC.
BEEP CODE #5 Brake fault Drive inhibited. Refer to BEEP CODE #5 - Brake Fault.
BEEP CODE #6 Throttle Trip Drive inhibited. The controller has detected that the throttle pot or throttle
control lever is not in the neutral position when turning the
key switch on or that the throttle pot may be faulty. Refer to
BEEP CODE #6 - Throttle Trip
BEEP CODE #7 Throttle Trip Drive inhibited. The speed pot or its wiring is faulty. Check for open or short
circuits. Speed Pot may not be correctly set up. Refer to
BEEP CODE #7 - Throttle Trip.
BEEP CODE #8 Motor Disconnected Drive inhibited. The motor or its wiring is faulty. Check for open or short
circuits. Refer to BEEP CODE #8 - Motor Disconnected.
BEEP CODE #9 Possible Controller Trip Drive inhibited. The controller has an internal fault. Refer to BEEP CODE #9
- Possible Controller Trip.
To Next Page
Loading...
