EasyManua.ls Logo

Pride Mobility Traveller Plus - User Manual

Pride Mobility Traveller Plus
43 pages
Save Page as PDF
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
Loading...
Including Models: Elite Traveller Plus
and Elite Traveller Plus HD
ELITE TRAVELLER PLUS

Table of Contents

Questions and Answers

  • M
    Mary WebbJul 26, 2025
    What to do if all systems on my Pride Mobility Travel Scooter are dead?
    • E
      ellisonwilliamJul 26, 2025
      If all systems on your Pride Mobility Travel Scooter appear to be dead, ensure the key is in the 'on' position. Check if the power down timer has been activated. Also, make sure the battery pack is correctly seated. Inspect the tiller console fuse under the battery pack and replace it with a new fuse of the correct rating if it's blown. Finally, push in the main circuit breaker reset button.
  • M
    Mark MaysAug 1, 2025
    What to do if the battery voltage is too low to operate my Pride Mobility Travel Scooter?
    • W
      Wesley HinesAug 1, 2025
      If the battery voltage is too low to operate your Pride Mobility Travel Scooter, ensure the batteries are fully charged. Charge the batteries fully until the charger and any meters indicate completion.
  • N
    Nancy HillAug 6, 2025
    What to do if controller trip on Pride Mobility Travel Scooter?
    • D
      David SalasAug 6, 2025
      If you experience a possible controller trip on your Pride Mobility Travel Scooter (if you attempted to install the battery pack while the key was inserted, or if the motor controller is in overheat protective mode), shut down your Travel Scooter for a minimum of several minutes to allow the controller to cool. Then, try reinserting the key into the key switch and turning the Travel Scooter on.
  • V
    Vincent PerryAug 12, 2025
    What to do if I have a solenoid brake trip on my Pride Mobility Traveller Plus Scooter?
    • J
      James SmithAug 12, 2025
      If you experience a solenoid brake trip on your Pride Mobility Scooter, it might be because the manual freewheel lever is in the freewheel position. Remove the key, then push the manual freewheel lever to the drive position, and restart your scooter.
  • D
    dmartinezAug 19, 2025
    What to do if throttle trip on Pride Mobility Traveller Plus Scooter?
    • S
      Steven FernandezSep 12, 2025
      If you experience a throttle trip on your Pride Mobility Scooter because the throttle control lever may have been depressed while inserting the key, release the throttle control lever completely, then reinsert the key.

Summary

I. INTRODUCTION

SAFETY OVERVIEW

Important safety information for product operation.

PURCHASERS AGREEMENT

Terms and conditions accepted upon product delivery.

II. SAFETY

PRODUCT SAFETY SYMBOLS

Explanation of symbols used to denote warnings and actions.

GENERAL SAFETY PRECAUTIONS

Essential safety practices before operating the scooter.

WEIGHT LIMITATIONS AND INCLINE SAFETY

Adhering to weight limits and safe operation on inclines.

BATTERY HANDLING AND ENVIRONMENTAL SAFETY

Precautions for handling batteries and operating in different environments.

III. YOUR TRAVEL SCOOTER

TILLER CONSOLE OPERATION

Controls located on the tiller, including key switch and throttle.

REAR SECTION COMPONENTS

Location and function of rear-mounted components like levers and wheels.

BATTERY PACK AND CHARGING COMPONENTS

Information on the battery pack, charger port, and circuit breaker.

IV. BATTERIES AND CHARGING

CHARGING YOUR BATTERIES

Safe and proper procedures for charging the scooter batteries.

FREQUENTLY ASKED QUESTIONS

Common questions and answers regarding batteries and charging.

V. OPERATION

GETTING ONTO AND OFF THE SCOOTER

Safe procedures for mounting, dismounting, and pre-ride checks.

OPERATING YOUR TRAVEL SCOOTER

How to drive the scooter, including steering and speed control.

VI. COMFORT ADJUSTMENTS

TILLER AND SEAT ADJUSTMENTS

Adjusting tiller angle, seat rotation, and armrest width.

SEAT HEIGHT ADJUSTMENT

Adjusting the height of the seat post for optimal positioning.

VII. DISASSEMBLY AND ASSEMBLY

DISASSEMBLY AND REASSEMBLY PROCEDURES

Step-by-step guide for disassembling and reassembling the scooter.

VIII. BASIC TROUBLESHOOTING

DIAGNOSTIC BEEP CODES

Understanding error codes indicated by audible beeps.

IX. CARE AND MAINTENANCE

TIRE PRESSURE AND EXTERIOR CARE

Maintaining tire pressure and cleaning exterior surfaces.

STORING AND DISPOSING THE SCOOTER

Proper procedures for storing and disposing of the scooter.

X. WARRANTY

LIMITED WARRANTY PERIODS AND EXCLUSIONS

Overview of warranty durations and items not covered.

Pride Mobility Traveller Plus Specifications

General IconGeneral
BrandPride Mobility
ModelTraveller Plus
CategoryScooter
LanguageEnglish

Related product manuals