EasyManuals Logo

Pride Mobility Go-Go Series User Manual

Pride Mobility Go-Go Series
31 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #16 background imageLoading...
Page #16 background image
16 Go-Go
TILLER CONSOLE
The tiller console houses all controls needed to drive your scooter, including the key switch, throttle control levers, horn
button, speed adjustment dial, and the battery condition meter. See figure 5.
WARNING! Do not expose the tiller console to moisture. In the event that the tiller console does
become exposed to moisture, do not attempt to operate your scooter until the tiller console has
dried thoroughly.
IV. YOUR GO-GO
Key Switch
n Fully insert the key into the key switch to power up (turn on) your scooter.
n Remove the key from the key switch to power down (turn off) your scooter.
Throttle Control Levers
These levers allow you to control the forward speed and the reverse speed of your scooter up to the maximum
speed you preset with the speed adjustment dial.
n Place your right hand on the right handgrip and your left hand on the left handgrip.
n Use your right thumb to push the right side of the lever to disengage your scooters brakes and move forward.
n Release the lever and allow your scooter to come to a complete stop before pushing the other side of the lever
to move in reverse.
n When the throttle is completely released, it automatically returns to the center stop position and engages your
scooters brakes.
Horn Button
The key must be fully inserted into the key switch for the horn to be operational.
n This button activates a warning horn.
n Do not hesitate to use the warning horn when doing so may prevent accident or injury.
Speed Adjustment Dial
This dial allows you to preselect and limit your scooters top speed.
n The image of the tortoise represents the slowest speed setting.
n The image of the hare represents the fastest speed setting.
Battery Condition Meter
When the key is fully inserted into the key switch, this meter indicates approximate battery strength. For further informa-
tion on the battery conditon meter, see V. Batteries and Charging.
BATTERY CONDITION METER
HORN BUTTON
KEY
(INSERTED INTO
KEY SWITCH)
SPEED ADJUSTMENT DIAL
THROTTLE CONTROL
LEVER
Figure 5. Tiller Console
THROTTLE CONTROL
LEVER

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Pride Mobility Go-Go Series and is the answer not in the manual?

Pride Mobility Go-Go Series Specifications

General IconGeneral
Weight Capacity300 lbs
Overall Width21 inches
Front Tires8 inches solid
Rear Tires8 inches solid
Battery Size12V 18Ah (x2)
Charger TypeOff-board
Seat-to-Ground Height19.5 inches

Related product manuals