23
Go-Go Ultra X www.pridemobility.com
Follow these easy steps to charge your batteries
safely:
NOTE: The battery pack can be charged on or off the
Travel Scooter.
1. Position your Travel Scooter or battery pack close to
a standard electrical outlet. See figure 10.
2. Remove the key from the key switch.
3. Make certain that the manual freewheel lever is in the
drive (rearward) position.
4. Plug the charger power cord into the charger power
cord receptacle on your Travel Scooter, then into the
electrical outlet. See figure 11. We recommend that
you charge the batteries for 8 to 14 hours.
NOTE: The LED lights on the charger indicate dif-
ferent charger conditions at various times. Refer to
the operating instructions supplied with the charger
for a complete explanation of these indicators.
5. When the batteries are fully charged, unplug the charger
power cord from the electrical outlet and then from
the charger power cord receptacle.
V. BATTERIES AND CHARGING
Figure 10. Charging The Batteries (Battery Pack Removed)
Figure 11. Off-Board Battery Charger
POWER
CHARGER
PLUGS INTO BATTERY PACK
PLUGS INTO STANDARD
ELECTRICAL OUTLET
NOTE: There is a charger inhibit function on your Travel Scooter. The Travel Scooter will not run and
the battery condition meter will not operate while the batteries are charging (when pack is being charged
on the Travel Scooter).
FREQUENTLY ASKED QUESTIONS
How does the charger work?
When your Travel Scooter’s battery voltage is low, the charger works harder, sending more electrical current to
the batteries to bring up their charge. As the batteries approach a full charge, the charger sends less and less
electrical current. When the batteries are fully charged, the current sent from the charger is at nearly zero
amperage. Therefore, when the charger is plugged in, it maintains the charge on your Travel Scooter’s batteries,
but does not overcharge them. We do not recommend that you charge your Travel Scooter’s batteries for more
than 24 consecutive hours.
What if my Travel Scooter’s batteries will not charge?
! Ensure that the fuse on the battery pack is in working condition.
! Ensure both ends of the charger power cord are inserted fully.