25
Go-Go Ultra X www.pridemobility.com
V. BATTERIES AND CHARGING
What type and size of battery should I use?
Your Travel Scooter requires two deep cycle batteries. We recommend only sealed, maintenance-free types such
as AGM or Gel-Cell. Do not use wet-cell batteries, which have removable caps. Refer to the specifications table
for size as batteries differ depending on manufacture.
WARNING! Corrosive chemicals are contained in batteries. Use only AGM or Gel-Cell
batteries to reduce the risk of leakage or explosive conditions.
NOTE: Sealed batteries are not serviceable. Do not remove the caps.
How do I change the batteries in my Travel Scooter?
WARNING! Contact your Pride Provider if you have any questions regarding the batteries
in your Travel Scooter.
WARNING! Do not replace the batteries while the Travel Scooter is occupied.
WARNING! The batteries on your Travel Scooter should only be serviced or
replaced by an authorized Pride Provider or a qualified technician.
MANDATORY! Battery posts, terminals, and related accessories contain lead and
lead compounds. Wear goggles and gloves when handling batteries and wash
hands after handling.
WARNING! Always use two batteries of the exact same type, chemistry, and amp-
hour (Ah) capacity. Refer to the specifications table in this manual and in the
manual supplied with the battery charger for recommended type and capacities.
Figure 12. Battery Replacement
BATTERY TERMINALS
BATTERY CABLES
1. Remove the battery pack from the Travel Scooter.
2. Carefully turn the pack upside down.
3. Remove the eight (8) screws from the perimeter
of the battery pack.
4. Carefully turn the pack right side up and remove
the lid.
5. Disconnect the black (-) and red (+) battery
cables from the battery terminals. See figure 12.
6. Remove the old battery.
7. Place a new battery in the battery pack.
8. Connect the red battery cable to the positive (+)
battery terminal.
9. Connect the black battery cable to the negative
(-) battery terminal.
10. Position the lid back onto the battery pack en-
suring all wires are inside the pack so they don’t
become pinched.
11. Carefully turn the pack upside down.
12. Reinstall all screws and tighten.
To Next Page
Loading...
Need help?
General
