Pride Mobility Go-Go Ultra X User Manual

32
www.pridemobility.com Go-Go Ultra X
ASSEMBLY
NOTE: Before attempting assembly, tilt the rear half of the Travel Scooter slightly back on the anti-tip
wheels as show in figure 19.
1. Use the frame release lever to lift the front section as you align the frame hooks of the front section with the
lower frame tube of the rear section. See figure 19.
2. Once the frame hooks are over the lower frame tube, lower the front section completely. This will engage the
frame lock-up.
3. Raise the tiller and fully tighten the tiller adjustment knob.
4. Reinstall the battery pack.
5. Reinstall the seat and rotate it until it locks into place.
6. Unlock the front wheel by turning the tiller lock knob 90° counterclockwise. See figure 18.
WARNING! After assembly, make absolutely certain the tiller lock knob is in the unlocked
position before riding your Travel Scooter.
VIII. DISASSEMBLY AND ASSEMBLY
FRAME RELEASE LEVER
FRAME HOOK
Figure 19. Frame Separation
LOWER FRAME TUBE
#

Pride Mobility Go-Go Ultra X Specifications

General

Brand	Pride Mobility
Model	Go-Go Ultra X
Category	Scooter
Language	English