EasyManuals Logo

Pride Mobility Go-Go User Manual

Pride Mobility Go-Go
35 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #31 background imageLoading...
Page #31 background image
31
Go-Go/Rev H/March 04 www.pridemobility.com
Your scooter requires a minimal amount of care and maintenance. If you do not feel confident in your ability to
perform the maintenance listed below, you may schedule inspection and maintenance with your authorized Pride
Provider. The following areas require periodic inspection and/or care and maintenance.
TIRE CONDITION AND TREAD WEAR
n Regularly inspect your scooters tires for signs of wear.
n Use a rubber conditioner on your scooters tire sidewalls to help to preserve them.
WARNING! Do not apply rubber conditioner on tire tread; this may cause the tires to become
dangerously slippery.
EXTERIOR SURFACES
n Bumpers and trim benefit from an occasional application of rubber or vinyl conditioner.
WARNING! Do not use a rubber or vinyl conditioner on the scooters vinyl seat, floorboard,
or tire tread. They will become dangerously slippery and result in personal injury and/or
damage to your scooter.
n The scooter shroud is made from durable ABS plastic and coated with an advanced formula urethane paint.
n A light application of car wax will help the shroud retain its high gloss.
WIRING HARNESS
n Regularly check the front-to-rear harness insulation for wear or damage.
n Have your authorized Pride Provider repair or replace any damaged connector, connection, or insulation that
you find before using your scooter again.
AXLE BEARINGS AND THE MOTOR/TRANSAXLE ASSEMBLY
n These items are all prelubricated, sealed, and require no subsequent lubrication.
CONSOLE, CHARGER, AND ELECTRONICS
n Keep these areas free of moisture.
n If any of these items do become exposed to moisture, let them dry thoroughly before operating your scooter again.
STORAGE
If you plan on not using your scooter for an extended period of time, it is best to:
n Fully charge its batteries prior to storage.
n Remove the battery pack.
n Store your scooter in a warm, dry environment.
n Avoid storing your scooter where it will be exposed to temperature extremes.
For prolonged storage, you may wish to place several boards under the frame of your scooter to raise the scooter
off of the ground. This takes the weight off the tires and reduces the possibility of flat spots developing on the areas
of the tires contacting the ground.
XII. CARE AND MAINTENANCE
WARNING! Always protect batteries from freezing temperatures and never charge a frozen
battery. This damages the battery and can cause personal injury.

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Pride Mobility Go-Go and is the answer not in the manual?

Pride Mobility Go-Go Specifications

General IconGeneral
Maximum Speed4 mph
Range per ChargeUp to 12.5 miles
Turning Radius33"
Overall Length40"
Overall Width21"
Top Speed4 mph
Weight Capacity300 lbs
Number of Wheels3
Battery ChargerOff-board
Seat Depth16 inches
Charger TypeOff-board
Drive SystemRear-wheel drive

Related product manuals