Jazzy Select Elite www.pridemobility.com 25
V. COMFORT ADJUSTMENTS
Figure 15. Underside of Armrest
Controller Position
You can move the controller in toward or out away
from the armrest, or change the position of the control-
ler for either left-hand or right-hand use.
WARNING! Do not place the controller
harness so that it can be pinched in
the seat frame or the power base
frame.
To extend the controller:
1. Flip up the armrest so it is perpendicular to the
floor.
2. Loosen the setscrew on the controller bracket. See
figure 15.
3. Slide the controller into or out of the armrest to the
desired position.
4. Tighten the setscrew to secure the controller.
To change the controller position:
1. Turn off the power to the controller.
2. Unplug the controller harness from the power base.
3. Cut the wire tie(s) that secure the controller harness
to the armrest and seat.
4. Flip up the armrest so it is perpendicular to the
floor.
5. Loosen the setscrew on the controller bracket. See
figure 15.
6. Slide the controller out of the armrest.
7. Loosen the setscrew in the other armrest.
8. Place the controller in the other armrest.
9. Tighten the setscrew to secure the controller.
10. Route the controller harness along the seat frame
and secure with wire ties. See figure 11.
11. Plug the controller connector into the power base.
See figure 6.
Foot Platform Height Adjustment
You may be able to adjust the height of the foot plat-
form. See figure 16.
To adjust the foot platform height:
1. Remove the hardware that secures the foot
platform to the foot platform bracket.
2. Move the foot platform to the desired height.
3. Reinstall the hardware that secures the foot
platform to the foot platform bracket and tighten.
Figure 16. Foot Platform Angle Adjustment
SETSCREW
ADJUSTMENT SCREW
HARDWARE
FOOT PLATFORM
BRACKET
26 www.pridemobility.com Jazzy Select Elite
Figure 18. Elevating Leg Rests
V. COMFORT ADJUSTMENTS
Figure 17. Swing-Away Footrests
Foot Platform Angle Adjustment
You can adjust the angle of the foot platform. See fig-
ure 16.
To adjust the foot platform angle:
1. Flip up the foot platform and locate the adjustment
screw.
2. Turn the adjustment screw to raise or lower the
front of the foot platform.
Swing-away Footrests
Swing-away Footrests (SFRs) enable you to rotate the
footrests to the side before you transfer onto or off of
your power chair. See figure 17.
To rotate the SFRs:
1. Push in the release lever.
2. Rotate the SFRs.
To adjust the SFR length:
1. Remove the adjustment screws from the footrest
extension.
2. Slide the footrest up or down to the desired length.
3. Reinstall the two adjustment screws.
Elevating Leg Rests
Elevating Leg Rests (ELRs) offer an infinite range of
adjustment for the leg angle and a footrest adjustment
range of 12-19 in. (30.48-48.26 cm). See figure 18.
To rotate the ELRs:
1. Push in release lever A.
2. Rotate the ELRs.
To adjust the ELR angle:
1. Push down release lever B.
2. Move the leg rest to the desired angle.
To adjust the ELR length:
1. Remove the two adjustment screws from the side
of each leg rest extension.
2. Slide the leg rest up or down to the desired length.
3. Reinstall the two adjustment screws.
ADJUSTMENT
SCREWS
RELEASE
LEVER B
RELEASE
LEVER A
LEG REST
EXTENSION
ADJUSTMENT
SCREWS
FOOTREST
EXTENSION
SFR RELEASE
LEVER
To Next Page
Loading...
