Jazzy 1107 www.pridemobility.com 23
To remove the seat:
1. Flip up the seat latch safety.
2. Squeeze the seat latch together. See figure 12.
3. Pull the front of the seat up.
4. Slide the seat forward and off of the power base.
Power Base Disassembly
The Jazzy 1107 power base disassembles into six parts for easy transportation and storage. See figure 13.
To disassemble the power base:
1. Turn off the power to the controller.
2. Disconnect the controller from the power base. See figure 6.
3. Remove the seat.
4. Press the foot platform release button and lift off the foot platform. See figure 13.
5. Flip down the battery box latches on each side of the power base. See figure 14.
6. Slide the battery boxes back and off of the power base.
7. Flip up the centre section latch. See figure 14.
8. Rotate the centre section forward.
9. Grab a side section by the side frame handle.
10. Lift the side section up and off of the centre section.
11. Grab the other side section by the side frame handle.
12. Lift the side section up and off of the centre section.
NOTE: Perform the disassembly steps in reverse order to assemble the power chair.
NOTE: During assembly, make sure the battery box latches are in the up (locked) position and the centre
section latch is in the down (locked) position.
IV. ASSEMBLY/DISASSEMBLY
Figure 13. Power Base Components
FOOT PLATFORM RELEASE BUTTON
RIGHT FRAME SECTION
LEFT FRAME SECTION
REAR BATTERY BOX
FRONT BATTERY BOX
FOOT PLATFORM
CENTRE SECTION
To Next Page
Loading...
