Pride Sonic - External Battery Pack Charging; Battery Charging Frequency and FAQs

Jazzy 1100
Rev. S/072706 www.pridemobility.com Page 21
Sonic IV. Shroud Assembly — Front
A1a — E1
A1b — E1
*A1c — E1
*A1d — E1
A2
A3
A4
A5
A6
A7
*B1
*C1
*D1
*E1
F1
G1
H1
I1
J1
REF #
SHDASMB3382
SHDASMB3383
SHDASMB3384
SHDASMB3914
DWR9905E012
DWR9905E008
SCRPPH1044
DWR9905E007
VELHOOK1000
VELLOOP1000
ELEASMB2949
ELEASMB2915
HARASMB1042
ELEASMB2911
WASSTND1026
DWR9905B031
DWR9905B032
VELHOOK1028
VELHOOK1016
PART #
SHROUD,ASSY,FRONT BODY,SONIC RED,SONIC, OFFBOARD CHARGER READY
SHROUD,ASSY,FRONT BODY,SONIC BLUE,SONIC, OFFBOARD CHARGER READY
SHROUD,ASSY,FRONT BODY,SONIC YELLOW,SONIC, OFFBOARD CHARGER READY
SHROUD,ASSY,FRONT,ONYX BLACK,SC50INT, OFFBOARD CHARGER READY
MAT,RUBBER,FLOOR,RIGHT, SONIC,E-9905-012
MAT,RUBBER,FLOOR,LEFT, SONIC,E-9905-008
SCREW,PPH,BLACK ZINC,M4-.7 X 12MM
COVER,PLASTIC,BLACK,MIDDLE, SONIC,E-9905-007
REUSABLE FASTENER,HOOK,1" X 1",W/ADHESIVE BACK
REUSABLE FASTENER,LOOP,1" X 1",W/ADHESIVE BACK
ELECTRONIC,ASSY,PANEL,OFFBOARD CHARGER, SONIC
ELECTRONIC,ASSY,PANEL,CIRCUIT BREAKER/FUSE, SONIC
ELECTRONIC,HARNESS,FRONT SHROUD, ELECTRONICS, SONIC
BATTERY,ASSY,12 AMP,W/NYLON CASE, SC50, SONIC
WASHER, FLAT,ZINC,M4
STRAP,1"W X 8.5"L,NYLON, W/HOOK & LOOP FASTENER,B-9905-031
STRAP,1"W X 3"L,NYLON, W/BUCKLE,B-9905-032
FASTENER,1/2"W 1"L W/ADHESIVE BACK,REUSABLE, HOOK
FASTENER,50MM X 130MM,REUSABLE, HOOK
DESCRIPTION
1
1
1
1
1
1
6
1
1
1
1
1
1
1
6
1
1
1
1
QTY
This color option has been discontinued.
Black color shroud is available only for French models.
Refer to SECTION IV. — Shroud Assembly — Electronics for the illustration and the parts list.
Refer to SECTION IV. — Shroud Assembly — Electronics for the illustration and the parts list.
Refer to SECTION IV. — Shroud Assembly — Electronics for the illustration and the parts list.
Refer to SECTION IV. — Shroud Assembly — Electronics for the illustration and the parts list.
Notes :
*A1c — E1
*A1d — E1
*B1
*C1
*D1
*E1
Top-level shroud assemblies contain illustrated raw shrouds designated with corresponding lower-case extensions. Raw shrouds are not available
individually. The assembly must be purchased. Parts without lower-case extensions will be included in all top-level assemblies.