33Zoom
X. CARE AND MAINTENANCE
The following areas require periodic inspection and/or care and maintenance.
TYRE PRESSURE
n For optimum scooter performance we recommend you maintain the tyre pressure between 30-35 psi.
TYRE CONDITION AND TREAD WEAR
n Regularly inspect your scooters tyres for signs of wear.
n Use a rubber conditioner on your scooters tyres to help to preserve them.
WARNING! Do not put rubber conditioner on tyre tread; this may cause the tyres to become
dangerously slippery.
EXTERIOR SURFACES
n Bumpers and trim also benefit from an occasional application of rubber or vinyl conditioner.
WARNING! Do not use a rubber or vinyl conditioner on the scooters vinyl seat; it may become
dangerously slippery.
n The tiller shroud, front shroud, and the rear shroud are formed from durable ABS plastic and coated
with an advanced formula urethane paint.
n A light application of car wax will help the shrouds retain their high gloss.
BATTERY TERMINAL CONNECTIONS
n Make certain that the terminal connections remain tight and uncorroded.
n The batteries must sit flat in the battery wells.
n The battery terminals should face the rear of the scooter.
WIRING HARNESSES
n Regularly check all wiring connections.
n Regularly check all wiring insulation, including the charger power lead, for wear or damage.
n Have your authorised Pride provider repair or replace any damaged connector, connection, or insulation
that you find before using your scooter again.
AXLE BEARINGS AND THE MOTOR/TRANSAXLE ASSEMBLY
n These items are all prelubricated, sealed, and require no subsequent lubrication.
CONSOLE, CHARGER, AND ELECTRONIC CONTROLLER ASSEMBLY
n Keep these areas free of moisture.
n If any of these items do become exposed to moisture, let them dry thoroughly before operating the
scooter again.
WARNING! Do not exceed 35 psi; overinflating a tyre can cause it to explode.
To Next Page
Loading...
