TROUBLESHOOTING
GUIDE
Oven
not
working:
• Check for the presence of mains electrical power
and ifthe oven
is
connected
to
the electrical
supply.
• Turn off
the
oven and restart
it
to
see
if
the fault
persists.
AFTER SALES SERVICE
Before
you call
the
After
Sales
Service:
I. Try
to
solve
the
problem yourself following
the points described
in
"Troubleshooting
Guide".
2. Turn
the
appliance off and on again, to make
sure that
the
problem
has
been solved.
If
after
the
above
checks
the
fault
still
occurs,
get
in
touch
with
the
nearest
After
Sales
Service.
12
Please
give:
• a brief description of the fault;
• the type and exact model of the oven;
• the service number (number after the word
Service on the rating plate), located on the
right hand edge of the oven cavity (visible
when the oven door
is
open). The service
number
is
also indicated on the guarantee
booklet;
• your
full
address;
• your telephone number.
1>11:WI4:1
oooo
ooo
ooooo
11111111111111111111111111111~11
IMPORTANT:
• Check that the oven control knob
is
not turned
to
"0"
or
to
"lamp"
-:Q:.
lfthe
electronic programmer (depending on
model) display presents the message
"5
& 0 P", consult the product description
sheet provided separately and/or
the
electronic programmer description.
-
If
the
electronic programmer (depending on
the model) presents the message
"F
HH",
contact the nearest After Sales Service.
Specify
in
this case the number that follows
the letter
"F".
If
any repairs are required, please contact
an
authorised
After
Sales
Service
(to guarantee
that original spare parts
will
be used and repairs
carried out correctly).
Failure
to
comply
with
these
instructions
may
compromise
the
safety
and
quality
of
the
product.
DECLARATION
OF
CONFORMITY ( E
• This oven
is
intended
to
come
into
contact
with
foodstuffs
and
conforms
to
DirectiVe
89/
I 09/EEC.
• This
appliance
is
designed
to
be
used
for
cooking
only.
Any
other
use
(e.g.
for
room
heating)
is
considered
as
improper
use
and
potentially
dangerous.
• This
appliance
has
been
designed,
constructed
and
marketed
in
compliance
with:
-
The
safety
requirements
of
"Low
Voltage"
Directive
73/23/EEC;
-
the
protection
requirements
of
EMC
Directive
89/336/EEC;
-
the
requirements
of
Directive
93/68/EEC.
To Next Page
Loading...
